Morning
I got started by gathering everything I need for across the street. I made some labels with Dean's label maker, laminated a sheet with all the P1223 TRG information, got together all the tools, soldered female header jumpers onto the signal wire, and grabbed my documents. I went over there and started the wiring. I pulled the two new cables, labeled, and swapped out resistors. The only problem is the switch didn't work. The DC trip just keeps going off. I ran out of time in the morning, so I'll have to troubleshoot later.
Afternoon
Tony was over here, so we just got started on the Mecop basic knowledge review. I had a good idea on most of the items, but he brought up good points with things like input impedance (0-10VDC signals should have high impedance, 4-20 mA should have low impedance, etc.) and sizing (NEC code book). I was able to answer a number of questions fairly well, but I still learned a lot. I started the drawings for the test bench rather than go back over for just a half hour.
No comments:
Post a Comment