Morning
EBW4 was acting up again. I went out after I heard of two alarms that were holding them out. I went down to the shop to ask Jim about it. He said that he had wired some cable for the new pot, but that it was just landed to a terminal strip. He removed it and the welder worked... for about five minutes. I called Lyon to get some help. Once he cleared them out, the thing ran a production electrode. I worked on cleaning up the mess around the plc. I also finished marking up the beam pattern design document.
Afternoon
EBW4 was sitting, then pumping, so I didn't need to worry about it much. I made the new I/O layout for 2 & 3. I also went through the drawings that I had made up and fixed a few things on them. I also never finished the analog plc drawing, so I fixed that up as well.
No comments:
Post a Comment